Fiber Optic Christmas Trees (HO-Scale)
I thought you might like to see the Christmas trees that I built using the 64 strand end glow cable that I purchased from you. The trees are built by using the fiber as the trunk and drilling small holes in each layer of a Faller tree kit, then I used a 5 minute epoxy to hold them in place.
The tree is then lit from the bottom with a bright LED or small lamp. The plastic trees have Woodland Scenics green ground foam then snow glued on with white glue before the fibers were finally trimmed. The Photo does not show the red very well. These trees are about 1.5 and 2 inches tall.
~ Thanks John!
Do you have a fiber optic project or model that you built? Would you like to show it off and share it with the world? If so, let us know! You could earn some free fiber optic filament! Click here for details